As the battery reaches its capacity, the charger slows down, carefully topping off the remaining "empty" cells.
Error codes like CAL , Err-2 , or UNST often mean your scale needs calibration. Here is the (note: your model may vary slightly). zyx-j30 manual
Getting your ZYX-J30 up and running takes only a few minutes if you follow these steps: Remove all protective films and foam inserts. As the battery reaches its capacity, the charger
| Pin | Signal | Direction | Description | |-----|--------|-----------|-------------| | 1 | VIN+ | Input | Power (12-24V DC) | | 2 | GND | Reference | Ground | | 3 | TXD | Output | RS-232 / TTL (selectable via jumper J4) | | 4 | RXD | Input | Serial receive | | 5 | A/B+ | I/O | CAN bus high (ISO 11898) | | 6 | A/B- | I/O | CAN bus low | | 7 | IO1 | Config. | Digital input (5-24V tolerant) / PWM output | | 8 | IO2 | Config. | Analog input (0-10V or 4-20mA, user selectable) | Getting your ZYX-J30 up and running takes only
usually features a single to cycle through its charging programs:
Specifically tuned for specialized batteries that require different voltage thresholds.
Check the fuse in the power plug and ensure the outlet is active.