make uboot make kernel make rootfs make app
The compilation process for Sigmastar is modular but generally follows a specific order. sigmastar sdk install
Installing the SigmaStar SDK is a crucial step in developing customized firmware and applications for smart devices based on SigmaStar SoCs. By following the steps outlined in this essay, you should be able to successfully install the SDK and configure your development environment. If you encounter any issues, refer to the troubleshooting section or contact SigmaStar support for assistance. With the SigmaStar SDK installed, you can now start developing innovative applications and firmware for your smart devices. make uboot make kernel make rootfs make app
cd project ./setup_config.sh ./configs/nvr/i2m/8.2.1/nor.glibc-squashfs.011a.64 make clean; make image Use code with caution. Copied to clipboard 4. Flashing the Image If you encounter any issues, refer to the
Once compiled, images are burned to the board using one of two methods: TFTP Burning : Ideal for rapid development. Set the board's in U-Boot, then use the command to download and flash images over Ethernet. ISP Tool / SD Card