Disable Zram Magisk -

The terminal returns an empty output or shows no lines containing /dev/block/zram0 .

For a permanent solution that survives reboots, create a custom boot script managed by Magisk. disable zram magisk

: A widely used Magisk module intended to kill both zRAM and physical disk swap at startup to preserve flash memory lifespan. You can source it directly from the rompelhd Swap-Disabler GitHub Repository . The terminal returns an empty output or shows

This is where —the systemless rooting interface—comes in. Using Magisk, we can disable ZRAM entirely without modifying the system partition. But be warned: Disabling ZRAM on a low-RAM device will cause apps to crash and reload frequently. You can source it directly from the rompelhd

#!/system/bin/sh # Wait for the system boot to fully complete sleep 30 # Turn off the active zRAM swap device if [ -e /dev/block/zram0 ]; then swapoff /dev/block/zram0 # Reset disksize to release the memory allocated to zRAM echo 1 > /sys/block/zram0/reset fi # Apply to secondary zRAM partitions if present for i in 1 2 3; do if [ -e /dev/block/zram$i ]; then swapoff /dev/block/zram$i echo 1 > /sys/block/zram$i/reset fi done # Set swappiness to 0 to instruct the kernel not to swap echo 0 > /proc/sys/vm/swappiness Use code with caution. Step D: Zip and Flash

After rebooting, you can verify if zRAM is truly disabled by using a terminal emulator (like Termux ) and running: su free -m Use code with caution. Copied to clipboard