AgTalk Home
AgTalk Home
Search Forums | Classifieds (87) | Skins | Language
You are logged in as a guest. ( logon | register )

JUQ-467 Disabled transmission on jd 8310
View previous thread :: View next thread
   Forums List -> Machinery TalkMessage format
 
pirlbeck
JUQ-467
JUQ-467 Posted 3/25/2021 07:48 (#8914531 - in reply to #8913926)
Subject: RE: Disabled transmission on jd 8310


West Central Iowa

Juq-467 [2021] Instant

Please provide more context, and I'll do my best to create an engaging story for you!

Below is a draft summary of the content based on its listing details: JUQ-467

Sure! I’d be happy to put together a guide, but I need a bit more information to make sure it’s exactly what you’re looking for. Could you tell me what refers to (e.g., a product, software tool, piece of equipment, etc.) and what kind of guide you need (setup, troubleshooting, user manual, best‑practice tips, etc.)? The more details you provide, the more useful the guide will be. Please provide more context, and I'll do my

Update maintenance logs automatically when a part is scanned. Could you tell me what refers to (e

Bound by silence and seething with jealousy, Tatsuya finds himself trapped under the same roof as the woman he once loved but could never satisfy. Night after night, he hears the muffled sounds of their intimacy through the thin walls — sounds he never heard during their marriage. The humiliation festers, but so does a dangerous desire.



I thought I would add this just in case someone runs into this problem WITHOUT having a fuse in the DIA location.

The DTAC solution # is 71449 dated 12-22-2010.

Solution Summary: 00/10/20 W/T tractor goes into diagnostic mode on its own.

Complaint or Symptom: Tractor goes into Diagnostic mode while operating in the field. Corner post display stops showing engine RPM and displays DIA while engine is running. Tractor can be shut off and restarted to return to normal operation. Circuit 312 acquires enough voltage from other circuits to place controller into diagnostic mode without a fuse in diagnostic mode position F10.

Solution: Insert a male spade terminal into diagnostic fuse F10 for circuit 312 (non-powered side). Connect the other end of this wire to a ground terminal in the power strip. This prevents circuit 312 from causing controllers to go into diagnostic mode without a fuse installed in position F10.

CAUTION: Make certain to use a voltmeter to identify which side of fuse holder F10 does not have 12 volts applied to it. Non-powered side of fuse F10 is connected to circuit 312.

I had a 8410 a couple of years ago with this problem and a ground wire cured it.
Top of the page Bottom of the page


Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread

(Delete cookies)